Advertisment
⇐ Back to Settings Index
ConnectCNC Port Settings
DNC / file transfer settings for Fagor 8040/55  

Set the following parameters on the machine:

Parameter
Value
P000 6 = 9600 Baud rate
P001 1 = 8 Data bits
P002 0 = No parity
P003 0 = 1 Stop bit
P004 0 = dnc
P005 NO = dnc active on power up
P006 YES = debug feature inactive
P007 0 = abort character)
P008 3 = LF
P009 2 = EOF
P010 OFF = Xon/Xoff

To set the CNC up for drip feed:
 ---drip feed not available on this control---

Set ConnectCNC as follows:

Common Settings
Name Fagor 8040/55
Baudrate 4800
Data bits 8
Stop bits 1
Parity None
Flow control Hardware
Xon Char. 17
Xoff char. 19
Port as available

Send Settings
Header String  
Trailer String  
End of Line Sequence
Recognize custom EOL  
Replace  
 
Check "%" character unchecked.
Skip empty lines Checked
Skip line numbers user's choice
Skip non printable bytes user's choice
Skip comments check "(...)" if required
Default folder Folder in which you store this machine's programs
Start transfer delay user's choice

Receive Settings
Header String  
Trailer String  
End of Line Sequence
Recognize custom EOL  
Replace (checked) 13,10
 
Check "%" character unchecked.
Skip empty lines Checked
Skip line numbers user's choice
Skip non printable bytes user's choice
Skip comments check "(...)" if required
Default folder Folder in which you store this machine's programs
Start transfer delay user's choice
Calculator
for
Machinists

Machinist's Calculator

Easily calculate:
  • Speeds and feeds
  • trigonomerty
  • thread measurement
  • surface finish
and more...
Free 30 day trial

More info..

machinistcalculator.com

Cable Pin Out for RS232 COMM port

Cable pinout for connecting Fanuc 16m

Sometimes file transfer will not run, even if all the settings are correct. Go to this page for solutions.
If you get a message that the port configurations are not saved, see this page for the solution.
Once you have ConnectCNC and your CNC machines communicating, we strongly suggest you take the following precautions:
- Download some programs, the longer the better, from your CNC to the pc. Save them under a temporary filename so you don't overwrite the original files. Examine them for errors such as dropped or changed text.
Do this for the first few programs that you use.

These settings have been collected from users of our software and machine tool distributers. We have listed them to help users of ConnectCNC to communicate between their computers and CNC controls.
Since we have no control over the many variables involved, including such things as cable conditions, modifications to machines, condition of computer hardware, etc., we take no responsibility for any damage caused to programs or machines through the use of this software.

Need a g-code editor? ConnectCNC is also bundled with EditCNC.